Skip to content

Param editor

You can edit the Parameter assigned to each FX column by entering a PARAM Editing Mode.

Here are the instructions for Param Editing mode:

Enter using SHIFT + KEYBOARD button. You will need to cycle passed the Value Editing Mode to enter the Param Editing Mode.

or

Enter using the menu

  • Enter PARAM EDITING MODE by pressing down on the SELECT Encoder to open up the Perform FX Menu
  • In the Perform FX menu, select the EDITING MODE sub menu and press down on Select Encoder to enter the menu
  • Change Editing Mode to PARAM

At any time you can Exit out of VALUE EDITING MODE using the BACK button

Param Editing Mode: - Param Editing Mode will show you an overview of the parameters that are assignable to the FX columns in Performance View by lighting dimly the shortcut pads for these parameters. - Parameters that have been assigned to one or more columns will have their shortcut pads lit up bright white. - Press on a shortcut pad to illuminate the FX columns that that parameter has been assigned to. - While holding a shortcut pad, press on the FX columns to assign or unassign a parameter to/from a column. - Press HORIZONTAL ENCODER ◀︎▶︎ + BACK to clear all existing Parameter assignments. - When a Parameter has not been assigned to a column, that column will not be lit and will be unusable in Performance View until you assign a Parameter. This applies to editing the values for that FX column as well (assign a Parameter first, then you can edit the values). - Parameters are saved to PerformanceView.xml. You can manually edit the Parameters in the xml as well, but you must use the exact Parameter names. It is recommended to save a fresh PerformanceView.xml and back it up so you have a record of the Parameter Names. - Once you are done with editing mode, press BACK to exit out to either the EDITING MODE sub menu or PERFORMANCE VIEW (depending on how you entered the PARAM EDITING MODE)